| Installation instructions for the
Tapcon® Masonry Fastening system. |
| Hole size is important. Use the close
tolerance carbide tipped masonry drill bit supplied with each Tapcon®
package. |
|
1)
Insert the drill bit supplied with the Tapcon anchors into the Condrive®
installation tool and drill hole in concrete through the
 fixtures mounting hole. (Because inserts are not
required, "spotting" of holes in unnecessary) The drilled hole must be at least
1/4" deeper than the anchor's's embedment depth. Minimum anchor's embedment
should be one inch.
2) Position Condrive's® drive sleeve and
insert head of anchor in hex socket or use Phillips bit. Position anchor in
drilled hole and drive until anchor is seated. Tapcon is available in slotted
hex washer head and Phillips flat head styles. |
 |
| CONDRIVE®
2000 - For rapid, repetitive hole drilling and driving of hex head Tapcon
anchors up to 2-3/4" long. Tool is chucked into standard hammer
drill. |
 |
CONDRIVE® 1000 - Tool with components
that can be used to drive hex head or Phillips head Tapcon anchors in all
lengths. Tool is chucked into standard hammer drill. |
 |
